The Brook Retro Board can be installed in any Panzer Fight Stick every sold. The level of difficulty with each may differ slightly. I will cover the Panzer 3 (and by extension the Panzer 2.0) in this article.
1. The Brook Retro Board can be used 100% on its own. You do not need to couple it with any other Brook products for it to work. I include a 20 pin male to male adapter for the Retro Board so you can connect the Panzer 3 EZ BUILD cable to it easily. The other cables (L3/R3 and DP/LS/RS) will connect as normal. Note: in the image below the connector for DP/LS/RS is not shown. See image below:
2. You can "stack" the Universal Fighting Board ON TOP of the Brook Retro Board coupling the 20 pin signal connection and the 4 pin USB pass through to the Retro Board if you want to use both PCBs. See the image below for how these stack electronically:
3. In both situations you will use a NEUTRIK CAT 5 RJ-45 Adapter to connect the RETRO BOARD to the outside of the case. This is an available option with the RETRO BOARD when purchased from jasenscustoms.com. It bolts into place just like the USB connector. Once the Adapter is installed you will connect a short CAT 5 Ethernet cable between the RETRO BOARD and the ADAPTER.